finishmatt
washabilitynon-washable
description
Dulux Trade Supermatt is a top quality, economical, high-opacity matt emulsion which gives excellent coverage and application. Suitable for all interior wall and ceiling surfaces, particularly new plaster that is still drying out. Dulux Trade Supermatt also has Airsure technology, and is 99.9% VOC Free*, to minimise the impact on indoor air quality**
* Based on in-can VOC content, measured in accordance with ISO 11890-2:2013.
** Independently tested for emissions, including formaldehyde, TVOC, TSVOC and Cat 1A & 1B carcinogens.
* Based on in-can VOC content, measured in accordance with ISO 11890-2:2013.
** Independently tested for emissions, including formaldehyde, TVOC, TSVOC and Cat 1A & 1B carcinogens.
Application Description
Application : Brush, roller or Airless spray.
To minimise picture framing or patchy finishes, we strongly recommend stirring the paint thoroughly prior to use. If thinned, the paint used for cutting-in and for rolling should be to the same ratio. Cut in one wall at a time, then rolling immediately afterwards, not allowing the cutting-in to dry prior to rolling. Cut in no more than 5 to 8cm away from any internal angles, including sockets/switches, skirting,
architraves, etc.
Seal new or bare surfaces with a thinned first coat of Dulux Trade Supermatt (up to 1 part clean water to 3 parts paint). The normal finishing process is 2 coats of Dulux Trade Supermatt (thinned up to 1 part clean water to 4 parts paint), however for significant colour change additional coats may be required. For best colour consistency, purchase sufficient tinted paint for each job at one time from the same source.
To minimise picture framing or patchy finishes, we strongly recommend stirring the paint thoroughly prior to use. If thinned, the paint used for cutting-in and for rolling should be to the same ratio. Cut in one wall at a time, then rolling immediately afterwards, not allowing the cutting-in to dry prior to rolling. Cut in no more than 5 to 8cm away from any internal angles, including sockets/switches, skirting,
architraves, etc.
Seal new or bare surfaces with a thinned first coat of Dulux Trade Supermatt (up to 1 part clean water to 3 parts paint). The normal finishing process is 2 coats of Dulux Trade Supermatt (thinned up to 1 part clean water to 4 parts paint), however for significant colour change additional coats may be required. For best colour consistency, purchase sufficient tinted paint for each job at one time from the same source.
×
surface calculator
enter your target area dimensions below so we can estimate how much you need for the job
